HUAWEI OptiX Metro 100 SDH

Brief Introduction

 

Developed to provide a complete solution for Huawei's optical transmission systems, the STM-1 type, case-shaped OptiX Metro 100 supports access of various services in the Local Area Network (LAN) or local transmission network. Working together with other equipment at the access layer, the product provides service access on the client side and transport for private line services.

 

Specification


Specifications

Metro 100

Aggregation

STM-1

Dimensions

43.6 mm (H) x 442 mm (W) x 220 mm (D)

Switch Capacity

1.25Gbit/s full higher order and lower order cross-connect capacity

Supported Interfaces

STM-1(o), E1(e), FE(e)

Power Supply

DC: -48V DC or -60V DC
AC: 220V/110V AC

Networking Mode

Supports multiple SDH networking topologies, such as chain, ring, tangent rings, intersecting rings, etc

Clock Synchronization

Line clock source
Tributary clock source 
One external clock input/output (2 Mbit/s)

Auxiliary Interface

10M/100M NM interface, external UPM management port, stack interfaces Alarm interface

 

Features


High Integration

  • Chassis dimensions: 442 mm (W) x 220 mm (D) x 43.6 mm (H)

  • Excluding the power supply module, all functional units are integrated into one board

 

Low Power Consumption, Natural Heat Dissipation

  • Supports a maximum power consumption of only 16 W

  • Supports natural heat dissipation and produces low noise

 

Various Management Systems

  • OptiX iManager NMS (Network Management System)

  • Web-LCT (Local Craft Terminal)

  • LCD (Liquid Crystal Display)

 

Carrier-class Protection

  • Supports the Radius security control, that is, the user names and passwords of all NEs are managed in a unified manner through the server of the user. Any user must pass the authentication before logging in to the NE. Therefore, the network security is high

  • SDH Network Protection

  • 1+1, 1:1 Linear MSP; SNCP (the switching duration is less than 50ms)

 

Highly Reliable Design

  • Power supply protection

The AC power input and the DC power input back up for each other. When only either of the power inputs is available, the NE can continue to operate properly. When neither power inputs is available, the device reports the alarm, indicating a power failure

 

  • Anti-reverse protection

The power supply provides anti-reverse protection

 

  • Lightning-proof protection

The power supply provides protection against lightning attack, overcurrent, and short-circuit

 

Flexible Installation

  • Mounted in a 19-inch cabinet, an ETSI 600 mm cabinet, or an ETSI 300 mm open cabinet

  • Wall-mounted

  • Desk-mounted

Various E1 Service Interfaces

  • RJ-45 (120Ω)

  • BNC (75Ω)

  • DB15 (X.21

5 other products in the same category:

Copyright © 2015.Sandes Information Technology All rights reserved. Power by websun